Cisco Catalyst 9500 User Manual

Device# debug platform condition stop
Conditional Debug Global State: Stop
Additional References for Conditional Debugging and
Radioactive Tracing
Related Documents
Document TitleRelated Topic
Command Reference (Catalyst 9500 Series Switches)For complete syntax and usage information for
the commands used in this chapter.
Feature History for Conditional Debugging and Radioactive
Tracing
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Feature InformationFeatureRelease
The Conditional Debugging feature allows you to
selectively enable debugging and logging for
specific features based on the set of conditions you
define.
Support for this feature was introduced only on the
C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
Conditional Debugging
and Radioactive Tracing
Cisco IOS XE Everest 16.5.1a
Support for this feature was introduced only on the
C9500-32C, C9500-32QC, C9500-48Y4C, and
C9500-24Y4C models of the Cisco Catalyst 9500
Series Switches.
Conditional Debugging
and Radioactive Tracing
Cisco IOS XE Fuji 16.8.1a
Use Cisco Feature Navigator to find information about platform and software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
309
Conditional Debug and Radioactive Tracing
Additional References for Conditional Debugging and Radioactive Tracing

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English