Cisco Catalyst 9500 User Manual

PurposeCommand or Action
• basic: Starts the basic test suite.
• complete: Starts the complete test suite.
• minimal: Starts the minimal bootup test
suite.
• non-disruptive: Starts the nondisruptive
test suite.
• per-port: Starts the per-port test suite.
Configuring Online Diagnostics
You must configure the failure threshold and the interval between tests before enabling diagnostic monitoring.
Scheduling Online Diagnostics
You can schedule online diagnostics to run at a designated time of day, or on a daily, weekly, or monthly
basis for a device. Use the no form of the diagnostic schedule switch command to remove the scheduling.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device #configure terminal
Schedules on-demand diagnostic test for a
specific day and time.
diagnostic schedule switch number test{name
| test-id | test-id-range | all | basic | complete |
Step 2
minimal | non-disruptive | per-port} {daily |
The switch number keyword is supported only
on stacking switches.
on mm dd yyyy hh:mm | port inter -port-number
port-number-list | weekly day-of-week hh:mm}
When specifying the test to be scheduled, use
these options:
Example:
Device(config)# diagnostic schedule
• name: Name of the test that appears in the
showdiagnostic contentcommand output.
switch 3 test 1-5 on July 3 2013 23:10
• test-id: ID number of the test that appears
in the show diagnostic content command
output.
• test-id-range: ID numbers of the tests that
appear in the show diagnostic content
command output.
• all: All test IDs.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
200
Configuring Online Diagnostics
Configuring Online Diagnostics

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English