Cisco IE-5000 User Manual

6
Configuration Overview
Default Settings After Initial Switch Configuration
— Interface speed and duplex mode is autonegotiate.
— Auto-MDIX is enabled.
— Flow control is off.
 VLANs
— Default VLAN is VLAN 1.
— VLAN trunking setting is dynamic auto (DTP).
— Trunk encapsulation is negotiate.
— VTP mode is server.
— VTP version is Version 1.
— Voice VLAN is disabled.
 STP, PVST+ is enabled on VLAN 1.
 MSTP is disabled.
 Optional spanning-tree features are disabled.
 FlexLinks are not configured.
 DHCP snooping is disabled.
 IP source guard is disabled.
 DHCP server port-based address allocation is disabled.
 Dynamic ARP inspection is disabled on all VLANs.
 IGMP snooping is enabled. No IGMP filters are applied.
 IGMP throttling setting is deny.
 The IGMP snooping querier feature is disabled.
 MVR is disabled.
 Port-based traffic
— Broadcast, multicast, and unicast storm control is disabled.
— No protected ports are defined.
— Unicast and multicast traffic flooding is not blocked.
— No secure ports are configured.
 CDP is enabled.
 UDLD is disabled.
 LLDP is disabled.
 SPAN and RSPAN are disabled.
 RMON is disabled.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes