Cisco IE-5000 User Manual

455
Configuring Port-Based Traffic Control
How to Configure Port-Based Traffic Control
Configuring Small-Frame Arrival Rate
Configuring Protected Ports
 pps pps—Specifies the rising threshold level for broadcast, multicast, or
unicast traffic in packets per second (up to one decimal place). The port
blocks traffic when the rising threshold is reached. The range is 0.0 to
10000000000.0.
 (Optional) pps-low—Specifies the falling threshold level in packets per
second (up to one decimal place). It can be less than or equal to the
rising threshold level. The port forwards traffic when traffic drops below
this level. The range is 0.0 to 10000000000.0.
For BPS and PPS settings, you can use metric suffixes such as k, m, and g
for large number thresholds.
4. storm-control action {shutdown |
trap}
Specifies the action to be taken when a storm is detected. The default is to
filter out the traffic and not to send traps.
 shutdown—Error-disables the port during a storm.
 trap—Generates an SNMP trap when a storm is detected.
5. end Returns to privileged EXEC mode.
Command Purpose
Command Purpose
1. configure terminal Enters global configuration mode.
2. errdisable detect cause small-frame Enables the small-frame rate-arrival feature on the switch.
3. errdisable recovery interval interval (Optional) Specifies the time to recover from the specified
error-disabled state.
4. errdisable recovery cause small-frame (Optional) Configures the recovery time for error-disabled ports to
be automatically reenabled after they are error disabled by the
arrival of small frames
5. interface interface-id Enters interface configuration mode, and specifies the interface to
be configured.
6. small violation-rate pps Configures the threshold rate for the interface to drop incoming
packets and error disable the port. The range is 1 to 10,000
packets per second (pps).
7. end Returns to privileged EXEC mode.
Command Purpose
1. configure terminal Enters global configuration mode.
2. interface interface-id Specifies the interface to be configured, and enter interface
configuration mode.
3. switchport protected Configures the interface to be a protected port.
4. end Returns to privileged EXEC mode.

Cisco IE-5000 Specifications

General

Brand	Cisco
Model	IE-5000
Category	Switch
Language	English