Cisco IE-5000 User Manual

182
Configuring Switch-Based Authentication
How to Configure Switch-Based Authentication
Command Purpose
1. show ip http server status (Optional) Displays the status of the HTTP server to determine if the
secure HTTP server feature is supported in the software. You should see
one of these lines in the output:
HTTP secure server capability: Present
or
HTTP secure server capability: Not present
2. configure terminal Enters global configuration mode.
3. ip http secure-server Enables the HTTPS server if it has been disabled. The HTTPS server is
enabled by default.
4. ip http secure-port port-number (Optional) Specifies the port number to be used for the HTTPS server. The
default port number is 443. Valid options are 443 or any number in the
range 1025 to 65535.
5. ip http secure-ciphersuite
{[3des-ede-cbc-sha] [rc4-128-md5]
[rc4-128-sha] [des-cbc-sha]}
(Optional) Specifies the CipherSuites (encryption algorithms) to be used
for encryption over the HTTPS connection. If you do not have a reason to
specify a particularly CipherSuite, you should allow the server and client
to negotiate a CipherSuite that they both support. This is the default.
6. ip http secure-client-auth (Optional) Configures the HTTP server to request an X.509v3 certificate
from the client for authentication during the connection process. The
default is for the client to request a certificate from the server, but the
server does not attempt to authenticate the client.
7. ip http secure-trustpoint name Specifies the CA trustpoint to use to get an X.509v3 security certificate
and to authenticate the client certificate connection.
Note: Use of this command assumes you have already configured a CA
trustpoint according to the previous procedure.
8. ip http path path-name (Optional) Sets a base HTTP path for HTML files. The path specifies the
location of the HTTP server files on the local system (usually located in
system flash memory).
9. ip http access-class
access-list-number
(Optional) Specifies an access list to use to allow access to the HTTP
server.
10. ip http max-connections value (Optional) Sets the maximum number of concurrent connections that are
allowed to the HTTP server. The range is 1 to 16; the default value is 5.
11. ip http timeout-policy idle seconds life
seconds requests value
(Optional) Specifies how long a connection to the HTTP server can remain
open under the defined circumstances:
 idle—Specifies the maximum time period when no data is received or
response data cannot be sent. The range is 1 to 600 seconds. The
default is 180 seconds (3 minutes).
 life—Specifies the maximum time period from the time that the
connection is established. The range is 1 to 86400 seconds (24
hours). The default is 180 seconds.
 requests—Specifies the maximum number of requests processed on
a persistent connection. The maximum value is 86400. The default
is 1.
12. end Returns to privileged EXEC mode.
13. show ip http server secure status Displays the status of the HTTP secure server to verify the configuration.

Cisco IE-5000 Specifications

General

Brand	Cisco
Model	IE-5000
Category	Switch
Language	English