EasyManuals Logo
Home>Cisco>Server>UCS C240 M5

Cisco UCS C240 M5 Service Manual

Cisco UCS C240 M5
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
On the outside of the assembly, push the green-arrow button toward the rear to open the securing plate.
Figure 7: Front Securing Mechanism, Inside of Front End
Securing plate shown pulled back to the open
position
3Front mounting pegs1
-Rack post between mounting pegs and opened
securing plate
2
Step 3
Install the outer slide rails into the rack:
a) Align one slide-rail assembly front end with the front rack-post holes that you want to use.
The slide rail front-end wraps around the outside of the rack post and the mounting pegs enter the rack-post holes
from the outside-front. See Figure 7: Front Securing Mechanism, Inside of Front End, on page 17.
The rack post must be between the mounting pegs and the open securing
plate.
Note
b) Push the mounting pegs into the rack-post holes from the outside-front.
c) Press the securing plate release button, marked PUSH. The spring-loaded securing plate closes to lock the pegs in
place.
d) Adjust the slide-rail length, and then push the rear mounting pegs into the corresponding rear rack-post holes. The
slide rail must be level front-to-rear.
The rear mounting pegs enter the rear rack-post holes from the inside of the rack post.
e) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are
at the same height and are level front-to-back.
f) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.
Step 4
Insert the server into the slide rails:
This server can weigh up to 64 pounds (29 kilograms) when fully loaded with components. We recommend
that you use a minimum of two people or a mechanical lift when lifting the server. Attempting this procedure
alone could result in personal injury or equipment damage.
Caution
a) Align the rear ends of the inner rails that are attached to the server sides with the front ends of the empty slide rails
on the rack.
Cisco UCS C240 M5 Server Installation and Service Guide
17
Installing the Server
Installing the Server in a Rack

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS C240 M5 and is the answer not in the manual?

Cisco UCS C240 M5 Specifications

General IconGeneral
BrandCisco
ModelUCS C240 M5
CategoryServer
LanguageEnglish

Related product manuals