Product Manual – DOC. 8432A Crestron Pyng OS 2 for CP4-R • 17
Pair Wireless Devices
To pair wireless devices with the Crestron Pyng system:
NOTE: For best practices regarding the installation and setup of Crestron RF (radio
frequency) products, refer to the Installation and Setup of Crestron RF Products Best
Practices Guide (Doc. 6689) at
www.crestron.com/manuals.
1. Select Crestron Wireless from the Device Types menu.
2. Select a wireless gateway from the Select Gateway Below menu.
Pair Devices Screen - EX Gateway
NOTES:
∙ A wireless gateway, such as the CEN-GWEXER, must be installed and
configured on the network prior to pairing devices. For more information,
refer to the gateway documentation.
∙ If a TSR-310 will be added to the system, ensure that the TSR-310 is
connected to a WAP that is in Crestron's list of recommended WAP
brands. For more information and a complete list of brands, refer to the
TSR-310 Supplemental Guide (Doc. 8226) at www.crestron.com/manuals
.
3. Tap Start Pairing to place the selected gateway into acquire mode.
4. Place the wireless device(s) into acquire mode as described in the device
documentation. Acquired devices display underneath the gateway on the
Pair
Devices screen.
To Next Page
Loading...
Need help?
General
