User's Manual
112
Select
Main Menu
>
Network
>
P2P
, you can go to
P2P
interface too.
Figure 4-22
Step 2 Check the box to enable P2P function.
After the P2P function is enabled and connected to the Internet, the system will
collects your information for remote access, and the information includes but not
limited to email address, MAC address, and device serial number.
Step 3 Click
Next
button to complete setup.
The status is online if the P2P registration is successful.
4.1.4.3.2 Client Operation
Step 1 Use your cell phone to scan the QR code under Cell Phone Client to download the
application.
Step 2 On your cell phone, open the application, and then tap .
Step 3 The menu is displayed. You can start adding the device.
1) Tap
Device Manager
.
The
Device Manager
interface is displayed. See Figure 4-23.
To Next Page
Loading...
Need help?
General
