Dahua NVR5432-XI User Manual

User's Manual
343
5.11.9 PPPoE
PPPoE is another way for the Device to access the network. You can establish network connection by
configuring PPPoE settings to give the Device a dynamic IP address on the WAN.
Prerequisites
To use this function, firstly you need to obtain the username and password from the Internet Service
Provider.
Procedure
Step 1 Select
Main Menu
>
NETWORK
>
PPPoE
.
Figure 5-232 PPPoE
Step 2 Enable the PPPoE function.
Step 3 Enter the username and password provided by the Internet Service Provider.
Step 4 Click
Apply
.
The IP address appears on the PPPoE page. You can use this IP address to access the
Device.
When the PPPoE function is enabled, the IP address on the
TCP/IP
page cannot be
modified.
5.11.10 DDNS
When the IP address of the Device changes frequently, the DDNS function can dynamically refresh
the correspondence between the domain on DNS and the IP address. You can access the Device by
using the domain.
Prerequisites
Check the type of DDNS that the Device supports and then log in to the website provided by the
DDNS service provider to register domain and other information.

Dahua NVR5432-XI Specifications

General

Brand	Dahua
Model	NVR5432-XI
Category	Network Hardware
Language	English