User's Manual
269
Table 5-44 Parameters of people No. exception detection
Parameter Description
Name Customize the rule name.
Sensitivity Set alarm sensitivity.
Duration
Set the minimum time to trigger an alarm after the system detects an
abnormal number of people.
Repeat Alarm Time
Set repeat alarm time. If the alarm-triggering event continues, an
alarm will be triggered again when repeat alarm time passed.
Alarm People No.
When the number of people in the area is greater than, equal to, or
less than the defined threshold, an alarm will be triggered.
3) Click
OK
.
Step 5 Configure alarm schedule and linkage.
Figure 5-162 Schedule and alarm linkage
1) Click .
2) Click
Setting
next to
Schedule
to configure the alarm period.
The system performs linkage actions only for alarms during the arming period.
●
On the time line, drag to set the period.
●
You can also click to set the period.
3) Configure alarm linkage. For details, see Table 5-50.
4) Click
Apply
.
Step 6 Click
Apply
.
5.9.8.2.5 People Stay Detection
When the target stays in the detection area longer than the defined duration, an alarm will be
triggered.
Procedure
Step 1 Select
Main Menu
>
AI
>
Parameters
>
Stereo Analysis
.
Step 2 Select a channel and then click
Add
.
Step 3 Select
Enable
and then set
Type
to
People Stay Detection
.
Step 4 Draw detection rule.
1) Click , and then draw a detection area on the video image. Right-click the image to
stop drawing.
To Next Page
Loading...
Need help?
General
