8 Dover Fueling Solutions W2940305 Rev 07 8/2019
1.4 Technical Information
Application: For dispensing low viscosity petroleum fuels - diesel, including biodiesel blends
up to 20%; kerosene; gasoline, including standard oxygenated blends; AvGas;
and Jet Fuel (check with fuel supplier for any metal flow path restrictions for
AvGas and Jet Fuel, you must install the appropriate filters, water separators,
etc. needed for the fuel type being used.) - from aboveground or underground
storage tanks in applications. Dispensers with the “E” Prefix utilize nickel-
plating, hard anodizing, stainless steel, special elastomers and a special fuel
filter. While standard dispensers are Listed to handle Ethanol products up to
an E10 blend, “E” prefix dispensers are Listed for use with products up to E85.
Dispensers with a first suffix “9” are equipped to handle up to E25 and B20
products. Dispensers with a “D” prefix are rated for use with DEF. Use
hanging hardware rated for the available fuel type dispensed.
Note: Dispenser
not Listed by a nationally recognized testing laboratory (NRTL) for Biodiesel (over
20%), AvGas, or Jet Fuel.
Performance: Enhanced Capacity: Up to 22 GPM (83 LPM) maximum test rate at discharge
outlet.
Super-High Capacity (SHC): Up to 30 GPM (114 LPM) maximum test rate at
discharge outlet.
Important: Actual flow rates will depend upon the installation conditions, product
dispensed, dispenser accessories, and for remote dispensers, the size of the
pump.
Electronic Head: iGEM electronics platform. Controls dispenser operation. Provides user
operating messages, transaction limit controls, error monitoring, enhanced
diagnostics. Allows software uploads/downloads via a PC. Infrared remote
control allows configuring settings, reading totalizers, and accessing diagnostic
tools. 120/240VAC 50/60 Hz operation.
Liquid Crystal
Displays:
Backlit displays, 1.5” (3.8 cm) seven-digit upper display, 1” (2.5 cm) six-digit
middle display, and ½” (1.3 cm) four-character lower display. Display function
varies according to options. One display assembly for lane-oriented models.
Two display assemblies for island-oriented model. Configurable 0-4 digits to
right of decimal. Programmable gallons or liters. In event of power loss, remain
visible for approximately 15 minutes.
Totalizers: 7-digit electromechanical non-resettable totalizer per product. One non-
resettable and one resettable electronic 6-digit totalizer. Electronic totalizers
display on volume display by using infrared remote control.
Light: LED light in electronic head provides lighting of bezel.
Fuel Control
System Interfaces:
Wayne dispenser US Current Loop protocol. Optional pulse output interface.
Meter: Enhanced Capacity and Super-High Capacity Models: 2-piston, positive
displacement iMeter fuel meter with integral intelligent pulser. E85 models
utilize Xflo
TM
fuel meter powered by DFS. Electronic calibration.
Filter: Enhanced Capacity Models comes with 10 micron internal filter. Super-High
Capacity comes with 30-micron hydrosorb internal filter. DEF units come
standard with a strainer and cap. A 5 micron filter kit is optional.
(Note: User should make sure the filter element meets the application and replace with
the appropriate element as necessary.)
Flow Control Valve: Enhanced Capacity and Super-High Capacity Models: Proportional 7/8”
(2.2cm) 24V valve. Super-High Capacity Models use 2 valves.
Inlet: All models: 1 ½” female NPT.
Outlet: All models: 1” female NPT. ¾” (1.9cm) reducing bushing supplied for ¾” hose
assemblies on non-SHC models.
Cabinet: Galvanealed metal. Removable front and rear doors. Optional SS.
Finish: Silver powder coat finish with blue powder coated doors. Optional black, green,
red, silver, white, or yellow powder-coated doors.
To Next Page
Loading...
Need help?
General
