For the purpose of this manual: the product designated on the front cover will be defined herein after
as the “Product;” and Dover Fueling Solutions (“DFS”), will reference different entities based on the
point of origin for which the Product is manufactured. For Products from North America, DFS
references Wayne Fueling Systems LLC located in Austin, Texas. For Products from Brazil, DFS
references Wayne Industria e Comercio Ltda. located in Rio de Janeiro, Brazil. For Products from the
United Kingdom, DFS references Dover Fueling Solutions UK Ltd. located in Dundee, Scotland. For
Products from China, DFS references Tokheim Hengshan Technologies Company, Ltd. located in
Guangzhou, China. For Products from India, DFS references Dover Fueling Solutions India Private
Limited.
READ THIS MANUAL BEFORE YOU BEGIN
Dispensers have both electricity and a hazardous, flammable, and potentially explosive liquid. Failure
to follow the below precautions and the Warning and Caution instructions in this manual may result in
serious injury or death. Read every tag attached to the dispenser before commencing installation.
Follow all rules, codes, and laws that apply to your area and installation.
SAFETY PRECAUTIONS - INSTALLATION AND MAINTENANCE
Always make sure ALL power to the dispenser (motors and electronic head) is turned OFF before you
open the dispenser cabinet for maintenance. Physically lock, restrict access to, or tag the circuit
breakers you turn off when servicing the dispenser. If applicable, be sure to trip (close) and test the
emergency valve(s) under the dispenser BEFORE beginning maintenance.
Make sure that you know how to turn OFF power to the dispenser and submersible pumps in an
emergency. Have all leaks or defects repaired immediately.
EQUIPMENT PRECAUTIONS
Be sure to bleed all air from the product lines of remote dispensers and prime suction pumps before
dispensing product, otherwise, damage to the equipment may occur. Always use the approved
method for lifting the dispenser. Never lift by the nozzle boot, sheet metal, etc., otherwise equipment
damage or personal injury may occur.
USE ONLY GENUINE PARTS
For product liability to be valid, no changes may be made to the equipment without the written
consent of Dover Fueling Solutions.
REGISTRATION OF SITE AND HOW TO CONTACT DFS
The equipment used at this site must be registered prior to contacting for warranty service. Sites can
be pre-registered prior to installation by a DFS Authorized Service Organization (ASO) via the on-line
registration system OR through completing the Section 1 portion of the form, at the end of this
manual, and sending it to DFS (for non-ASOs). Pre-registration of a site helps to expedite warranty
service in case it is needed. Please allow 2-3 days after receipt of the information for pre-registration.
Final registration, which requires all of the information pertaining to the site including Start-Up date
and equipment serial numbers, must be completed within 7 days of the completion of the Start-Up
using the same aforementioned methods.
Trouble with the installation of this product should be referred to your DFS ASO. An ASO with a
technician number can receive assistance by calling the DFS Support Center at:
1-800-926-3737
Customers, Installers or Distributors who are not an ASO, needing help with the operation or
installation of this product, should contact the DFS Support Center at:
1-800-289-2963 OR support.austin@doverfs.com
DANGER
To Next Page
Loading...
Need help?
General
