Enterasys D-Series User Manual

set cdp auth
5-4 Discovery Protocol Configuration
set cdp auth
UsethiscommandtosetaglobalCDPauthenticationcode.
Syntax
set cdp auth auth-code
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Theauthenticationcodevaluedeterminesaswitch’sCDPdomain.Iftwoormoreswitcheshave
thesameCDPauthenticati oncode,theywillbeenteredintoeachother’sCDPneighbortables.If
theyhavedifferentauthenticationcodes,theyareindifferentdomainsandwillnotbeentered
intoeachother’sCDPneighbor
tables.
Aswitchwiththedefaultauthenticationcode(16nullcharacters)willrecognizeallswitches,no
matterwhattheirauthenticationcode,andenterthemintoitsCDPneighbortable.
Example
ThisexampleshowshowtosettheCDPauthenticationcodeto1,2,3,4,5,6,7,8:
D2(su)->set cdp auth 1,2,3,4,5,6,7,8:
set cdp interval
Usethiscommandtosetthemessageintervalfrequency(inseconds)oftheCDPdiscovery
protocol.
Syntax
set cdp interval frequency
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
auth‐code SpecifiesanauthenticationcodefortheCDPprotocol.Thiscanbeupto16
hexadecimalvaluesseparatedbycommas.
frequency SpecifiesthetransmitfrequencyofCDPmessagesinseconds.Validvalues
arefrom5to900seconds.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English