Enterasys D-Series User Manual

set ciscodp status
Enterasys D-Series CLI Reference 5-9
set ciscodp status
UsethiscommandtoenableordisabletheCiscodiscoveryprotocolgloballyontheswitch.
Syntax
set ciscodp state {auto | disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtogloballyenableCiscoDP:
D2(su)->set ciscodp state enable
set ciscodp timer
UsethiscommandtosetthenumberofsecondsbetweenCiscodiscoveryprotocolPDU
transmissions.
Syntax
set ciscodp timer seconds
Table 5-3 show ciscodp port info Output Details
Output Field What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 6-1.
State Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
enabled can be changed using the set ciscodp port command.
vvid Whether a voice VLAN ID has been set on this port. Default of none can be changed
using the set ciscodp port command.
trusted The trust mode of the port. Default of trusted can be changed using the set ciscodp
port command.
cos The Class of Service priority value for untrusted traffic. The default of 0 can be
changed using the set ciscodp port command.
auto GloballyenableonlyifCiscoDPPDUsarereceived.
disable GloballydisableCiscodiscoveryprotocol.
enable GloballyenableCiscodiscoveryprotocol.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English