Enterasys D-Series User Manual

show pwa
Enterasys D-Series CLI Reference 17-63
show pwa
Usethiscommandtodisplayportwebauthenticationinformationforoneormoreports.
Syntax
show pwa [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,PWAinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayPWAinformationforge.2.1:
D2(su)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1 disabled disconnected 60 16
Table 17‐49providesanexplanationofthecommandoutput.
show pwa session 17-72
set pwa enhancedmode 17-73
For information about... Refer to page...
port‐string (Optional)DisplaysPWAinformationforspecificport(s).
Table 17-49 show pwa Output Details
Output Field What It Displays...
PWA Status Whether or not port web authentication is enabled or disabled. Default state of
disabled can be changed using the set pwa command as described in “set pwa” on
page 17-64.
PWA IP Address IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the set pwa ipaddress command as described in
“set pwa ipaddress” on page 17-67.
PWA Protocol Whether PWA protocol is CHAP or PAP. Default setting of PAP can be changed
using the set pwa protocol command as described in “set pwa protocol” on
page 17-67.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English