Enterasys D-Series User Manual

set rmon event properties
15-14 RMON Configuration
set rmon event properties
UsethiscommandtoconfigureanRMONevententry,ortocreateanewevententrywithan
unusedeventindexnumber.
Syntax
set rmon event properties index [description description] [type {none | log | trap
| both}] [community community] [owner owner]
Parameters
Defaults
Ifdescriptionisnotspecified,nonewillbeapplied.
Ifnotspecified,typenonewillbeapplied.
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,read‐write.
Table 15-41 show rmon event Output Details
Output Field What It Displays...
Index Index number for this event entry.
Owner Text string identifying who configured this entry.
Status Whether this event entry is enabled (valid) or disabled.
Description Text string description of this event.
Type Whether the event notification will be a log entry, and SNMP trap, both, or none.
Community SNMP community name if message type is set to trap.
Last Time Sent When an event notification matching this entry was sent.
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
description
description
(Optional)Specifiesatextstringdescriptionofthisevent.
typenone|log|
trap|both
(Optional)SpecifiesthetypeofRMONeventnotificationas:none,alog
tableentry, anSNMP
trap,orbothalogentryandatrapmessage.
community
community
(Optional)SpecifiesanSNMPcommunitynametouseifthemessage
typeissettotrap.FordetailsonsettingSNMPtrapsandcommunity
names,referto“CreatingaBasicSNMPTrapConfiguration”on
page 7‐37.
ownerowner (Optional)
Specifiesthenameoftheentitythatconfiguredthisentry.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English