Transmission Options
135
Fax
4
1 Select [Communication Mode] on
the [Transmission Options] screen.
2 Set the communications mode.
îš„G3 Auto
Select this mode if the remote machine is G3 compatible. This mode is the one
normally selected.
In accordance with the reception capabilities of the remote machine, the machine
automatically switches modes in the following order of priority: G3 Unique ECM J G3
Unique J ITU-T G3 ECM J ITU-T G3.
îš„F4800
Select this mode when transmitting over noisy or poor telephone lines, as can be the
case with overseas calls.
Also select this mode when transmitting over noisy or poor telephone lines
domestically.
îš„G4 Auto
Do not use this mode.
Note • [G4 Auto] is displayed on when an Internet Fax kit is installed. This setting applies the
transmission speed between the fax gateway and destination fax for the iFax.
F4800
You can communicate with faxes overseas via telephone company exchanges, etc.
Note • The international telephone networks are originally designed for voice communications.
Noise that does not really affect voice communications causes a problem with fax
communications. It may result in the deterioration of images quality, the inability to transmit a
fax, or even terminate the transmission. Regardless of whether transmission is successful,
you are charged for the call once the line is connected. For information on line trouble and
call charges, contact your telephone company.
Note • If you select [F4800], the transmission time may be longer because transmission is
performed at 4800 bps or less to ensure transmission is successful.
1 Select [Communication Mode] on
the [Transmission Options] screen.
2 Select [F4800], then [Save].
3 Enter the telephone company ID
number, "0011", country code, area
code, and recipient fax number as shown below.
Important • In some areas, you may need to enter a pause after the telephone company ID number.
Priority Send / Delayed Start (Specifying Send Priority/Send Time)
If you set the send priority, you can send faxes prior to stored documents or use the
polling feature.
Note • This feature is unavailable for iFax.
• If the Priority Send feature is selected during transmission, the fax will be sent after the
current transmission ends.
To Next Page
Loading...
Need help?
General
