HP-GL2 Emulation
585
Appendix
16
îš„Advanced Settings
Color Mode 105 1 (Default): Color
2: Monochrome
Sets the color mode.
Auto Layout 106 0 (Default): ON
1: OFF
Selects whether aligning the position of the document and the paper is to
be done automatically or not.
Active Palette 107 0 (Default): Command
1: Panel
Selects whether to use a pen specified by command or set on the panel.
No. of Prints 108 1
- 250 (Default): 1): 1 - 250
Sets the number of prints to be made.
Output Tray 109 0 (Default): Center Output Tray
1: Side Output Tray
80: Finisher Tray
Sets the output tray.
Two-Sided
Printing
110 0 (Default): None
1: Head to head
2: Head to toe
Sets the two-sided printing.
[None]...Prints one side.
[Head to Head]...Place the paper as in the [Paper Orientation], and it
prints both sides so that the orientation of the up-sides are aligned for
each page when the left side is closed.
[Head to Toe]...Place the paper as in the [Paper Orientation], and it prints
both sides so that the orientation of the up-sides are aligned for each
page when the top side is closed.
Chinese Fonts 111 0: Stroke
Specifies 2-byte character fonts, including Chinese characters. The
setting cannot be changed for this model.
Alphanumeric
Fonts
112 0: Stroke
Specifies 1 byte character fonts. The setting cannot be changed for this
model.
Vertical Position
Adjustment
113 0 (Default): Does not move the hard clip area.
1 to 500: -250 to +250 mm
Moves the hard clip area vertically.
-1
to -250 mm for setting numbers 1 - 250
+1
to +250 mm for setting numbers 251 - 500
To Next Page
Loading...
Need help?
General
