16 Appendix
600
Appendix
16
Example 1)
When you select [2 sheets J 1 sheet (2-up)] for Document 1 (4 pages) and [No] for
Document 2 (2 pages), both Documents 1 and 2 are set to [No] and the number of
printed pages is calculated as follows:
z
Total pages: 4
z
2 up: 0
Example 2)
When you select [No] for Document 1 (4 pages) and [2 sheets J 1 sheet (2-up)] for
Document 2 (2 pages), both Documents 1 and 2 are set to [2 sheets J 1 sheet (2-up)]
and the number of printed pages is calculated as follows:
z
Total pages: 5
z
2 up: 5
The numbers of pages for 2in1, 4in1, and 8in1 are also calculated in the same way as
above on DocuLyzer and ApeosWare Accounting Service.
The meter on the [Billing Meter] screen calculates the number of printed pages
correctly regardless of the [Multiple-up] setting.
îš„Printing in the spool mode
When you set [Receive Buffer] to [Memory] or [Hard Disk], the pages for a job is printed
in the order specified on the system, but the pages for different jobs may not be printed
in correct order in cases such as when you print multiple jobs by specifying one page
for each job. In such cases, set [Receive Buffer] to [Off].
îš„S/MIME Untrusted E-mail Reception
When [No] has been selected for [Receive Untrusted E-mail] or [Receive Untrusted
iFax] under [PKI (Public Key) Settings] J [S/MIME Settings] in the System
Administration mode, setting [Read Receipts (MDN)] or [Delivery Receipts (DSN)] to
[On] will be invalid and you will not get receipts.
îš„Addresses Registered on Job Flows
When an abbreviated number or address registered on Address Book has been used
for a job flow creation on the machine, any number of address change on Address Book
will not be reflected to the job flow. To send to the changed address, the address
registered on the job flow must be directly changed.
Notes and Restrictions in the Interrupt Mode
If you press the <Interrupt> button while running a print job, the machine temporarily
stops printing and goes into the interrupt mode.
Important • However, if a scan job is running at the same time, the print job cannot be interrupted.
The jobs that can be/cannot be interrupted are as follows.
Job
Job Instruction
from the
Control Panel
*
1
Job
Execution
Copy Required O
Print Printing of a document
*2
instructed from a
client computer
Required
*4
O
Printing of a document*
3
instructed from
[Job Status] > [Stored Documents]
Required O
To Next Page
Loading...
Need help?
General
