10 System Settings
304
System Settings
10
Receiving Buffer - USB
Set the receiving buffer for USB.
You can specify the value within the range from 64 to 1024 KB in 32 KB increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Receiving Buffer - LPD Spool
îš„Off
Does not use spooling. While LPD print processing is being carried out for one client, data
cannot be received over the same interface from another client.
Specify a value for the dedicated LPD receiving buffer memory capacity from 1,024 to 2,048
KB, in 32 KB increments.
îš„Memory
Carries out spooling. The receiving buffer for spooling uses a memory. When this setting is
selected, specify the memory capacity of a receiving buffer for spooling from 0.50 MB to
32.00 MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases, select
[Hard Disk] or [Off].
îš„Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Receiving Buffer - NetWare
Set the NetWare receiving buffer.
Specify a value from 64 to 1,024 KB in 32 KB increments.
Receiving Buffer - SMB Spool
îš„Off
Does not use spooling. While SMB print processing is being carried out for one client, data
cannot be received over the same interface from another client.
Specify a value for the dedicated SMB receiving buffer memory capacity from 64 to 1,024 KB
in 32 KB increments.
Important • If you select [Off], job names are displayed as "unknown document name".
îš„Memory
Carries out spooling. The receiving buffer for spooling uses a memory. When this setting is
selected, specify the memory capacity of a receiving buffer for spooling from 0.50 to 32.00
MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases, select
[Hard Disk] or [Off].
îš„Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Receiving Buffer - IPP Spool
îš„Off
Does not use spooling. While IPP print processing is being carried out for one client, data
cannot be received over the same interface from another client.
Set a value for the dedicated IPP receiving buffer memory capacity from 64 to 1,024 KB in 32
KB increments.
îš„Hard Disk
To Next Page
Loading...
Need help?
General
