Setup Menu
333
System Settings
10
Send as iFax
Specify an address for iFax transmission.
You can specify a total of up to 100 addresses, using either address numbers or direct input.
Important • It is not possible to use wildcard or group dial number specifications.
îš„Address Number
Specify an address with an address number. Enter the address number with the numeric
keypad, and select [Save]. The specified address appears in [Recipient Name/E-mail
Address] on the [Send as iFax] screen.
îš„New Recipient
Specify a new address. Select the item you want to change, and select [Change Settings].
The specified address appears in [Recipient Name/E-mail Address] on the [Send as iFax]
screen.
îš„Delete Recipient
Deletes all information for the selected addresses.
îš„Change Settings
Confirm or change the selected recipients.
For information about the method for confirm/change, refer to Address Book (Address Number)
(P.334).
Print
Make print settings. When [On] is selected, you then configure print settings.
îš„Quantity
Set the number of copies from 1 to 999, in 1 copy increments.
îš„Paper Supply
Select the printing paper tray. When [Auto Paper] is selected, the same paper size as the
original size is printed.
Note • When printing the fax document for Private Polling and Fax to Mailbox, if [Tray Mode] in
[Receive Paper Size] is selected, the document will be printed automatically on the paper
loaded on the bypass tray in case the specified paper tray cannot be used. For information
on [Receive Paper Size] settings, refer to Receiving Paper Size (P.317)
z
Auto Paper
A suitable paper tray is automatically selected.
z
Trays 1 to 4
Select paper from 4 trays.
z
Bypass
Prints on paper loaded in the Tray 5 (Bypass).
îš„2 Sided Printing
Sets the 2-sided printing option.
îš„Output
Perform the stapling, hole punching, and output destination settings.
z
Stapling
Set the position for stapling.
z
Hole Punching
Set the position for punching.
z
Output Destination
Select the output destination.
Edit/Delete
Check the content of a job flow sheet, and edit, copy, or delete it.
To Next Page
Loading...
Need help?
General
