EasyManuals Logo
Home>Fujitsu>Server>Primergy RX100 S3

Fujitsu Primergy RX100 S3 User Manual

Fujitsu Primergy RX100 S3
287 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
147
PRIMERGY RX100 S3 User’s Guide
5
Operations after OS Installation
5.3.2 Recovering the BIOS Information
If the information configured with the BIOS Setup Utility was deleted due to a drain of the built-in
server battery, etc., restore the BIOS information according to the following procedures.
Do not turn off the server during a program run.
Before starting up the system, check that the "OS Boot Monitoring" function of ServerView is disabled
(it is disabled by default).
If you start the system with the "OS Boot Monitoring" function enabled, the server operation may
become unpredictable, i.e., an abrupt power interruption or unintended restart may occur.
If the server is operated with the "OS Boot Monitoring" function enabled, enable the function again
before resuming operation. For details of ServerView, refer to "ServerView User’s Guide".
1 Turn on the server and insert the "Server Management Tools" disk into the
floppy disk drive.
The window for selecting a keyboard appears.
2 Select a keyboard.
Select [1] for Japanese keyboard or select [2] for English keyboard. Japanese keyboard is
selected by default.
3 When the DOS prompt window appears, confirm that the BIOS stored
information files are in the floppy disk.
Enter the following command to confirm that "*.SCS" (file names vary depending on BIOS
version), "FSCSMCTR.DAT", "BIOSCMP.TXT", "LAN_CFG.DAT", and "MUX_CONF.DAT"
are in the floppy disk.
A:\SMT>dir
4 Enter the following command and press the [Enter] key.
A:\SMT\>biosrest.bat
5 If the BIOS information is restored correctly, the following message appears.
6 The BIOS information will be enabled after the next system restart. Restart the
server.
Perform Step 1 to display the DOS prompt window.
The restoration procedure has been completed. The server can now be turned off safely.
Please select:
1 = JP Keyboard
2 = US Keyboard
Your selection
NORMAL END

Table of Contents

Other manuals for Fujitsu Primergy RX100 S3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu Primergy RX100 S3 and is the answer not in the manual?

Fujitsu Primergy RX100 S3 Specifications

General IconGeneral
BrandFujitsu
ModelPrimergy RX100 S3
CategoryServer
LanguageEnglish

Related product manuals