254
Chapter 9 Operation and Maintenance
9.3 System Event Log
To operate system event log, use the [IPMI] submenu of the [Server] menu in BIOS
Setup Utility and the Server Management Tools.
When the area for writing to the system event log is full, the server is set to automatically overwrite
older event logs. For details on this setting, refer to "8.1.10 IPMI Submenu" (pg.214) under the
[Advanced] menu of the BIOS Setup Utility.
9.3.1 How to Use Server Management Tools
This section explains how to use Server Management Tools.
Server Management Tools perform the following operations for system event logs stored in the
Baseboard Management Controller (BMC: a micro-controller on the baseboard that manages
temperature and voltage sensors).
• Viewing the system event log
• Saving the system event log
• Deleting the System Event Log
When a system event log occurs, save the log using Server Management Tools and contact an office
listed in the "Contact Information" of "Start Guide".
The "Server Management Tools" disk supplied with this server is for use with this server only. Do not
use those tools on other systems. If it is used, the system can be damaged.
Make sure to start up the server with the "
■ Starting Server Management Tools" (pg.255) before
running Server Management Tools. Do not run Server Management Tools on the server started from
the hard disk drive or by the other floppy disks. Otherwise, the system may be corrupted.
Do not eject the floppy disk when the floppy disk access LED is on. Doing so may destroy the data on
the floppy disk.
To Next Page
Loading...
Need help?
General