212
Chapter 8 Configuring Hardware and Utilities
8.1.8 Advanced System Configuration Submenu
This submenu appears when selecting "Advanced System Configuration" from the advanced menu.
Use this menu to configure the settings which are related to CPU, memory and USB.
table: Items on the Advanced System Configuration Submenu
Item Setting Description
ECC Memory Checking Enabled (Unchangeable) Sets whether to enable or disable to check ECC
error of memory.
PCI Bus Parity Checking Enabled (Unchangeable) Sets whether to enable or disable the PCI bus parity
checking.
BIOS Work Space Location
Top of Base Memory
(Unchangeable)
Sets the location on the memory to assign the data
area that BIOS uses.
Hyper-Threading • Disabled
• Enabled (Initial value)
Sets whether or not to run one CPU as a dual-
processing CPU. The setting [Enabled] may
enhance processing performance by allowing
maximum use of the processor resources.
This item is displayed only when Intel
®
Pentium
®
4
processor is installed.
Limit CPUID Functions Disabled (Unchangeable) Sets whether or not to limit CPUID expanded
function. If the OS does not support expanded
function, the system may not start.
CPU Mismatch Detection Enabled (Unchangeable) Sets whether to enable or disable checking the CPU
type and frequency.
CPU Halt Mode (CIE) • Standard (Initial value)
•Enabled
Configures the CPU internal setting.
This item is displayed only when Intel
®
Pentium
®
4
processor is installed.
CPU Thermal Management • Standard (Initial value)
•Enabled
Configures the CPU internal setting. This item is
displayed only when an Intel
®
Celeron
®
D
processor 341 is installed.
NX Memory Protection • Disabled (Initial value)
•Enabled
Sets whether to enable or disable "execute disable
bit function" of processor.
CPU Timeout Counter Enabled (Unchangeable) Configures the CPU internal setting.
Item Specific Help
Select Item
Select Menu
Change Values
Select Sub-Menu
-/+
Enter
F1
Esc
Help
Exit
F9
F7
Setup Defaults
Previous Values
Advanced Security Server ExitMain
If all memory in the
systm supports parity
(x72) this selections
enables ECC mode.
Advanced System Configuration
ECC Memory Checking:
PCI Bus Parity Checking:
BIOS Work Space Location:
Hyper-Threading:
Limit CPUID Functions:
CPU Mismatch Detection
CPU Halt Mode(C1E):
CPU Thermal Management:
NX Memory Protection:
CPU Timeout Counter
Enhanced SpeedStep:
CPU MC Status Clear:
[Enabled]
[Enabled]
[Top of Base Memory]
[Enabled]
[Disabled]
[Enabled]
[Standard]
[Standard]
[Disabled]
[Enabled]
[Disabled]
[Next Boot]
To Next Page
Loading...
Need help?
General