277
PRIMERGY RX100 S3 User’s Guide
Appendix
A
B.4 Internal Hard Disk Unit Specifications
■ Package
• Internal hard disk unit (1)
•Screws (4)
■ Specifications
*1: The value indicates memory capacity of the formatted hard disk (1GB = 1000
3
bytes).
*2: Hot-pluggable carrier is not included.
B.5 Power Cord Selection
The power cord for this unit has been packed separately and has been selected according to the country
of destination. It must be used to prevent electric shock. Use the following guidelines if it is necessary to
replace the original cord set.
The female receptacle of the cord set must meet CEE-22 requirements (see Figure).
■ For the United States and Canada
Use a UL listed and CSA labeled cord set consisting of a three conductor cord with a maximum length
of 15 feet.
For units which stand on a desk or table, type SVT or SJT cord sets should be used.
For units which stand on the floor, only SJT type cord sets should be used.
The cord set must be selected according to the current rating for your unit.
Please consult the table below for the selection criteria for power cords used in the United States and
Canada.
table: Internal Hard Disk Unit Specifications
Item
Functions and Specifications
Model PG-HDH71V PG-HDH41V PG-HDH31V
Interface Ultra 320 SCSI
Storage media 3.5-inch hard disk
Memory capacity
*1
73.4 GB 146.8 GB 300GB
Maximum data transfer rate 320MB/s (Ultra 320)
Average latency speed 3.0ms
Rpm 10,000rpm
Dimensions (W × D × H)
*2
101.6 × 146.0 × 25.4 (mm)
Weight
*2
0.73kg
To Next Page
Loading...
Need help?
General