______________________________________________________________________________
____________________________________________________________________________
LMM for the Kodiak 100 Page 1-1
190-02102-00 Rev.4
1 INTRODUCTION
This manual contains line maintenance information for the Garmin G1000 NXi Integrated
Avionics System installed in the Kodiak 100 aircraft.
All screenshots shown in this manual are included for visual reference only
and might not reflect the information displayed during actual G1000 NXi
system operation.
1.1 Line Maintenance
Performing line maintenance on the G1000 NXi system consists of the following tasks:
• Loading and Configuring System Software
• Troubleshooting
• LRU Replacement
• Reloading Software and Configuration
• LRU Testing and Calibration
• LRU Periodic Maintenance
Line maintenance involves identification and replacement of a faulty LRU. The LRU is
sent to Garmin for further diagnosis and repair. Component level LRU repair is beyond
the scope of maintenance described in this manual.
1.2 Support Equipment
Standard avionics support equipment is used to perform line maintenance.
1.3 Special Tools
No special tools are required to perform line maintenance.
1.4 Required Software
The G1000 NXi system is functional only after airframe-specific software and
configuration have been loaded. The correct loader card with the correct software
version is required. The system includes optional features that require the correct
software enablement card for activation. Refer to Section 3.
1.5 Materials
No materials are needed.
1.6 Consumables
No consumable items are required.
1.7 Expendables
No expendable items are required.
To Next Page
Loading...
Need help?
General
