Garmin G1000 Line Maintenance Manual

______________________________________________________________________________
____________________________________________________________________________
Page 3-32 LMM for the Kodiak 100
190-02102-00 Rev.4
Configure K Factor
1. Select the FUEL TANK CALIBRATION Page in the CAL Page Group.
2. Using the softkeys along the bottom of the screen, enter the following pass code:
12, 11, 10, 9. The cursor should now appear on the screen.
NOTE
Softkeys are numbered 1 to 12, left to right.
3. Turn the outer FMS knob counterclockwise to move the cursor and highlight ENG
1 K Factor in the Fuel Flow window.
4. Enter the five-digit K Factor (calculated in the above section) as follows:
a) Turn the inner FMS knob to select the first digit.
b) Turn the outer FMS knob to move the cursor to the right one digit.
c) Turn the inner FMS knob to enter the desired number.
d) Repeat steps B and C until all five K Factor digits have been entered.
5. Press the ENT key.
6. Press the FMS knob to turn off the cursor.
3.12.3 Engine Serial Number
Make sure the engine serial number is correct:
1. Select the AIRFRAME CONFIGURATION Page.
2. Press the FMS knob. Turn the large FMS knob until the ENGINE S/N field is high-
lighted.
3. Use the large and small FMS knob to enter the engine serial number in the
following format: RBXXXX, where XXXX is a four-digit number.
4. Press the ENT key.
Uncontrolled if Printed

Garmin G1000 Specifications

General

Brand	Garmin
Model	G1000
Category	Avionics Display
Language	English