______________________________________________________________________________
____________________________________________________________________________
Page 5-8 LMM for the Kodiak 100
190-02102-00 Rev.4
5.2.8 GEA 71/71B Engine and Airframe Interface Unit Replacement
Installation Manual Part Number: 190-01807-00
Captive Screw Hardware Replacement Instructions: 190-00313-65
1. To Remove:
a) Loosen the Phillips screw to unlock unit handle (for units with a D ring unlock
the handle by twisting the D-Ring counterclockwise 90°).
b) Pull the unit lever up towards the top of the unit. This disengages the locking
stud with the dogleg slot.
2. To Reinstall:
a) Inspect the connectors for damaged pins.
b) Gently push the unit into the rack to engage the connectors.
c) Push the unit lever down towards the bottom of the unit avoiding the use of
excessive force.
d) If the lever fails to go down, adjust the backplate while engaging the unit.
e) Lock the GEA 71/71B in place using the lever-locking handle.
f) Tighten the Phillips screw (or push in the D-Ring and twist clockwise 90° for
units with a D-Ring).
The application of torque exceeding 14 in-lbs. to the screw may result in
damage to the LRU case and/or retaining hardware. If the retaining hard-
ware is damaged during installation, a replacement hardware kit, Garmin
part number K00-00652-00, is available. Reference Garmin part number
190-00313-65 for instructions on replacing the retaining hardware.
g) Torque the captive screw to 10-14 in-lbs.
To Next Page
Loading...
Need help?
General
