Cineloop
Vivid S70 / S60 – User Manual 4-7
BC092760-1EN 01
Using cineloop
Selection of a cineloop
1. Press Freeze.
The left and right markers are displayed on either side of the
last detected heart cycle on the ECG trace.
2. Press 2D Freeze.
The selected heart beat is played back.
3. Press 2D Freeze to freeze the cineloop.
4. Use the trackball to scroll through the acquisition and find
the sequence of interest.
5. Adjust Cycle select to move from heart beat to heart beat
and select the heart cycle of interest.
6. Adjust Num cycles to select the number of heart beats to
play back.
7. In Freeze, press Set left or Set right to set the
corresponding cineloop boundary to the current frame.
8. Adjust Left marker and Right marker to trim or expand the
cineloop boundaries.
9. Press 2D Freeze to run the cineloop and Store to store the
cineloop ( ‘Storing a cineloop’ on page 10-8) or Freeze to
return to live scanning.
NOTE: Cineloop storage can be configured to store heart cycles
with additional time before and after the R-wave and to
display a preview before storage ( ‘Global imaging settings’
on page 12-17).
Adjustment of cineloop playback
1. Use the trackball or adjust Speed to set the speed of the
cineloop playback.
The speed factor (%) is displayed on the right side of the
ECG.
To view a cineloop frame by frame
1. In freeze, use the trackball or adjust Frame to scroll through
the cineloop frame by frame.
To Next Page
Loading...
Need help?
General
