Customize Configuration
12-60 Vivid S70 / S60 – User Manual
BC092760-1EN
01
Data Streaming
NOTE: Data streaming is for informational purposes only and not
intended for diagnostic use.
NOTE: The StreamServer option key should be installed to enable
streaming live ultrasound data.
The system has the capability to stream live ultrasound image
data (both 2D and 3D) over the network connection to enabled
devices. To configure this capability perform the following steps:
Enable data streaming
1. Press More on the control panel, then Utility
2. Press Config… on the control panel
3. Select the tab Connectivity, then TCP/IP
4. Press the button Data Streaming Settings
5. Check Enable Streaming on the Data Streaming Settings
dialog
6. Enter stream server Port No (or use the default port)
User setup for data streaming
Only a member of the group “ConsultingPhys” will have
permission to receive streamed data.
See example of users who can receive streaming data below.
To Next Page
Loading...
Need help?
General
