September 2007
6-46 General Programming
DONE? Option The Done? option is used to exit the Set Error Handling? submenu
and return to the main General menu. At the next prompt, the
following two responses are available:
• Yes - exit immediately to the main General menu
• No - remain in the Set Error Handling? submenu
This completes the prompts for the Done? option. Go to the
appropriate section of this chapter, based on the selection made
above, for further programming instructions.
RESUME Menu The Resume? option is used to exit the Main Menu and return to
normal Run mode to take live readings. At the next prompt (see the
menu map in Figure C-2 on page C-2), the following two responses
are available:
• Yes - return immediately to Run mode
• No - remain in the Main Menu for further programming
This completes the prompts for the Resume? option. If you selected
[N] above, go to the appropriate section of this chapter for further
programming instructions. Otherwise, simply continue taking live
readings.
TEST INPUTS
Press [Y] or [Enter] to return to
the main General menu, or press
[N] to remain in the Set Error
Handling? submenu.
Done?
GENERAL MENU
Press [Y] or [Enter] to return to
normal Run mode, or press
[N] to
remain in the Main Menu.
Resume?
To Next Page
Loading...
Need help?
General
