To Next Page

To Previous Page

September 2007

6-2 General Programming

Entering the General

To switch the XMO2 from Operate Mode to Programming Mode,

proceed as follows:

Note: If the XMO2 is set up for Easy Menu Entry, pressing

[Shift]+[2]

switches the XMO2 directly to Programming Mode and enters

the General Menu. See Chapter 7, Advanced Programming,

for instructions on setting up Easy Menu Entry.

Note: An * is displayed after each digit is entered. If you enter an

incorrect code, press a non-numeric key, or press the keys too

quickly, the XMO2 will return to Operate Mode.

General Menu Options The General Menu consists of the following six menu options:

• Calibrate System? - The factory calibration data may be accessed

via this menu option.

• Calibrate Recorder? - The default analog output high and low

values may be accessed via this menu option.

• Test Inputs? - For diagnostic purposes, various input parameters

may be accessed via this menu option.

• Test Recorder? - For diagnostic purposes, the analog output values

may be accessed via this menu option.

• Set Error Handling? - the manner in which the XMO2 responds to

various error conditions is specified in this menu option.

• Resume? - Use this menu option to either return to Operate Mode

or return to the Calibrate System? menu option.

Refer to Figures C-2 through C-6 in Appendix C, Menu Maps, and

proceed to the appropriate section to program the desired General

Menu option.

xx.xx %O2

Press [Y] or [ENTER].

Enter Code:

Press the [3], [6], and [9] keys

slowly and firmly, in sequence.

GENERAL MENU

You now have access to the

General Menu.

Calibrate System?

GE XMO2 User Manual

Questions and Answers: