To Next Page

To Previous Page

September 2007

7-2 Advanced Programming

Entering the Advanced

To switch the XMO2 from Operate Mode to Programming Mode,

proceed as follows:

Note: If the XMO2 is set up for Easy Menu Entry, pressing

[Shift]+[3]

switches the XMO2 directly to Programming Mode and enters

the Advanced Menu. See the instructions later in this chapter

to set up Easy Menu Entry.

Note: An * is displayed after each digit is entered. If you enter an

incorrect code, press a non-numeric key, or press the keys too

quickly, the XMO2 will return to Operate Mode.

Advanced Menu Options The Advanced Menu consists of the following six menu options:

• Setup? - You may specify the gas type, background gas display and

type, pressure measurement type, and the Easy Menu Entry status

via this menu option.

• Calibrate System? - The advanced calibration and operational

parameters for the XMO2 may be set via this menu option.

• Calibrate Recorder? - The 4-20 mA analog output may be

calibrated via this menu option.

• Set Error Handling? - The manner in which the XMO2 responds to

various error conditions is specified in this menu option.

• Erase RAM? - All user-entered data may be purged from the

XMO2’s memory via this menu option.

• Resume? - Use this menu option to either return to Operate Mode

or remain in the Advanced Menu.

Refer to Figures C-7 through C-9 in Appendix C, Menu Maps, and

proceed to the appropriate section to program the desired Advanced

Menu option.

xx.xx %O2

Press [Y] or [ENTER].

Enter Code:

Press the [9], [5], and [1] keys

slowly and firmly, in sequence.

ADVANCED MENU

You now have access to the

Advanced Menu.

Setup?

GE XMO2 User Manual

Questions and Answers: