Advanced Programming 7-29
September 2007
DONE Option The Done? option returns the XMO2 to the Advanced main menu
from the Set Error Handling? submenu. To use this option, refer to
the menu map in Figure C-9 on page C-9 and press
[N] until the
following prompt appears.
You may now do one of the following:
• Press [N] as many times as necessary to select another desired Set
Error Handling? option. Then, press
[Y] and proceed to the
appropriate section for instructions.
• Press [Y] to leave the Set Error Handling? submenu and return to
the top level of the Advanced menu.
ERASE RAM Menu Caution!
This procedure permanently deletes all user-entered
data from the XMO2’s memory. Once deleted, this data
cannot be recovered.
The Erase RAM menu is used to delete all user-entered data from the
XMO2’s memory. Refer to Figure C-7 on page C-7 and enter this
menu from the Advanced Menu prompt as follows:
Caution!
If you select [YES] at the following prompt, all user-
entered data will be permanently deleted from the
XMO2’s memory and cannot be recovered.
Press
[NO] at the above prompt to select another Advanced Menu
option for programming or to exit the User Program (see page 7-30).
SET ERROR HANDLING
Respond as indicated below.
Done?
ADVANCED MENU
Press [N] until this prompt
appears, then press
[Y] or [Enter].
Erase RAM?
WARNING: Erase RAM?
Press [N] to select the desired
option, then press
[Y] or [Enter] to
confirm your selection and move
to the next prompt.
[YES] no
ADVANCED MENU
This completes the programming
of this menu.
Erase RAM?
To Next Page
Loading...
Need help?
General
