GE XMO2 User Manual

Advanced Programming 7-3
September 2007
SETUP Menu The Setup? menu is used to specify the gas type, background gas
type, pressure measurement type, and the Easy Menu Entry status. To
enter this menu from the Advanced Menu prompt, proceed as follows:
The following submenus are included in the Setup? menu:
• Set Gas Type?
• Set Background Display?
• Set Pressure Type?
• Set Easy Menu Entry?
• Done?
Refer to Figure C-7 on page C-7 for a flow diagram of the Setup
menu, and proceed to the appropriate section for instructions.
SET GAS TYPE Option The Set Gas Type? option is used to specify the gas to be measured by
the XMO2 (the default gas is O
2
). Refer to Figure C-7 on page C-7
and proceed as follows:
You may now do one of the following:
• Press [N] as many times as necessary to select another Setup menu
option. Then, press
[Y] and proceed to the appropriate section of
this chapter for instructions.
• Press [N] until you reach the Done? option of the Setup menu, then
press
[Y] to return to the top level of the Advanced Menu.
ADVANCED MENU
Press [N] until this prompt
appears, then press
[Y] or [Enter].
Setup?
ADVANCED MENU
Press [N] until this prompt
appears, then press
[Y] or [Enter].
Set Gas Type?
Select Gas Type:
Press [N] to select the desired gas,
then press
[Y] or [Enter] to
confirm your selection.
[%O2] %H2 %N2 %SO2 %CO2
ADVANCED MENU
You have now completed the
programming of this submenu.
Set Gas Type?

GE XMO2 Specifications

General

Brand	GE
Model	XMO2
Category	Transmitter
Language	English