gefran 650 User Manual

80208G_MHW_650-1250-1350_01-2017_ENG
127
4. CONFIGURATION
4.23.10. MSG.SB - Selecting the message assigned to Sbr
Acronym Scrolling message Submenu Attributes
MSG.SB NUM SCROLLING MSG WHEN MAIN IN IS SB ERR HMI R W
The parameter shows and sets the number of the message assigned to Err (sensor break in short circuit or input values
above maximum limit), i.e., the scrolling message shown on the display.
For more information on scrolling messages, see paragraph “3.1.2.2. Scrolling messages” on page 34.
If the parameter is set to “0” no message will be displayed for Sbr.
As default, MSG.SB is assigned the message “4” (for LANG1 corresponds to ““SENSOR BROKEN”, for LANG2 corre-
sponds to “SONDA APERTA”).
Unit of measurement: Message number
Options: 0...25
4.23.11. LAnG - Selecting language for messages
Acronym Scrolling message Submenu Attributes
LAnG MESSAGE LANGUAGE HMI R W
The parameter shows and sets the language for the scrolling messages.
Unit of measurement: -
Options: LANG1 = Language 1 (English)
LANG2 = Language 2 (Italian)
LANG3 = Language 3
4.23.12. SPEED - Message scrolling speed
Acronym Scrolling message Submenu Attributes
SPEED SCROLLING MESSAGE SPEED HMI R W
The parameter shows and sets the message scrolling speed.
“1” corresponds to maximum scrolling speed, “10” to minimum speed.
With “0” the message does not scroll and the display shows first 5 characters (on models 650 and 1250) or the first 7
characters (on model 1350).
Unit of measurement: -
Options: 0...10 (default = 3)
Note: Messages with the description of the parameters always flow at a constant speed.
NOT are subjected parameter setting SPEED
4.23.13. BACKL - Backlighting level
Acronym Scrolling message Submenu Attributes
BACKL BACKLIGHT LEVEL HMI R W
The parameter shows and sets the backlight level on the display (when the controller is on) 10 seconds after the last key
has been pressed.
With “0,” the backlight does not switch off, but goes to the minimum useful level for reading the display.
The backlight goes to maximum level when any key is pressed.
Unit of measurement: -
Options: 0...10 (default = 8)

gefran 650 Specifications

General

Brand	gefran
Model	650
Category	Temperature Controller
Language	English