gefran 650 User Manual

80208G_MHW_650-1250-1350_01-2017_ENG
92
4. CONFIGURATION
Acronym Scrolling message Password Description
PID.GR PID GROUP
PARAMETERS CONFIG
Level 1 Lets you configure groups of control parameters. Groups of
control parameters must be enabled with the parameter PID.
GN = .1...4 on the MODE menu (the menu is not shown if
PID.GN = 0).
Groups are used to preconfigure sets of function parameters
that can be easily called when needed, without having to re-
configure the PID parameters every time. The number of pa-
rameters available in groups is less than the number on the
PID submenu. The number of parameters available in groups
is limited to those for PID heating and/or cooling control.
4.14. PID.GR Submenu – Configuring groups of control parameters
93
93
93
93
93
94
94
94
94
94
95
95
Selecting the
parameter
group to be
configured
Parameter
page
Parameter
page
Proportional
heating band
or hysteresis in
ON-OFF control
Integral heating
time
Derivative
heating time
Maximum
limit of heating
power
Minimum
limit of heating
power
Proportional
cooling band
or hysteresis in
ON-OFF control
Integral cooling
time
Derivative
cooling time
Maximum
limit of cooling
power
Minimum
limit of cooling
power
Threshold PV for
the activation of
the group of PID
parameters
PID.G.R
H.PB
H.IT
H.DT
H.P.HI
H.P.LO
C.PB
C.IT
C.DT
C.P.HI
C.P.LO
PV.THR

gefran 650 Specifications

General

Brand	gefran
Model	650
Category	Temperature Controller
Language	English