INSPECTION
Relieve the fuel pressure
and
disconnect the fuel
injector side quick connect fitting (page 7-6).
Wipe
up
any
spilled
Place the end of the hose into
an
approved gasoline
gasoline.
container.
Temporarily connect the negative
(-)
cable
[1]
to the
battery and fuel pump
5P
connector.
Turn the ignition switch
ON
and
engine stop switch
"0".
Measure the amount of fuel flow.
NOTE:
• The fuel pump operates for 2 seconds. Repeat 5
times to meet the total measuring time.
Return fuel
to
the fuel tank when the first fuel
is
finished.
Amount
of
fuel flow:
'13 model: 98 cm
3
(3.31
US
oz, 3.45 Imp oz)
minimum/10 seconds
After '13 82
cm
3
(2.77 US oz, 2.89 Imp oz)
model: minimum/10 seconds
If fuel flow
is
less than specified, inspect the following:
- Clogged fuel hose
- Fuel pump unit (page 7-10)
- Clogged fuel filter (page 7-10)
Connect the quick connect fitting and normalize the fuel
pressure (page 7-7).
'13
1.
Fuel Pressure Test 1.
Perform the fuel pressure test (page 7-8).
Standard: 263 - 316 kPa (2.7 - 3.2 kgf/cm
2
,
38-46
psi)
Is the fuel pressure within specification?
YES - GO TO STEP
3.
NO
- GO TO STEP
2.
2.
Fuel Pressure Test 2.
Check for any erratic swings or vibrations of the
gauge needle.
Are there any erratic swings
or
vibrations
of
the
gauge needle?
YES -
Replace the fuel filter (page
7-11
).
NO -
Replace the fuel pump unit (page 7-10).
FUEL SYSTEM
To Next Page
Loading...
Need help?
General
