FINAL REDUCTION
NG
0.2-
0.8 mm
(0.01 - 0.03 in)
DRIVES HAFT
BEARING (6204)
LEFT
CRANKCASE
DRIVES
HAFT
BEARING (6002 UU)
LEFT
CRANKCASE
COVER
OIL
SEAL
20
X
32
X
6
COUNTERS HAFT
BEARING (6301)
LEFT CRANKCASE
34
X
52
X
7
Be careful
not
to
Separate the final reduction case (page
13-6).
damage the final
Remove the countershaft [1] and final gear shaft [2]
reduction case
bearings using the special tools.
mating surface.
TOOLS:
Countershaft bearing:
[3] Bearing remover head, 12 mm
[4] Bearing remover shaft, 12 mm
[5] Remover weight
Final gear shaft bearing:
Bearing remover head, 15 mm
Bearing remover shaft, 15 mm
Remover weight
U.S.A. TOOLS:
Countershaft bearing:
07936-1660110
07936-1660120
07741-0010201
07936-KC10200
07936-KC10100
07741-0010201
Bearing remover, 12 mm
Remover handle
Remover weight
07936-16601
OA
07936-3710100
07936-371020A
Final gear shaft bearing:
· Bearing remover, 15 mm
Remover weight
07936-KC10500
07936-371020A
Apply engine
oil
to
each bearing [1j cavity.
Set the bearings
Drive each new bearing into the left crankcase squarely
with their marked
until it
is
fully seated, using the special tools.
sides facing
up.
13-8
TOOLS:
Countershaft bearing:
[2] Driver
[3] Attachment, 37 x 40 mm
[4] Pilot, 12 mm
Final gear shaft bearing:
Driver
Attachment, 42 x 47 mm
Pilot, 15 mm
07749-0010000
077 46-0010200
077 46-0040200
077 49-0010000
077 46-0010300
077 46-0040300
Assemble the final reduction case (page
13-12). ·
1.0 - 1.4
mm
(0.04 - 0.06 in)
DRIVES
HAFT
· BEARING (6202)
COUNTERS
HAFT
BEARING (6201)
FINAL
GEAR
SHAFT
BEARING (6205 UU)
To Next Page
Loading...
Need help?
General
