FINAL REDUCTION
Separate the final reduction case (page 13-6).
Remove the driveshaft bearing
[1]
and countershaft
bearing
[2]
using the special tools.
TOOLS:
Driveshaft bearing:
[3] Bearing remover head, 15 mm
[4] Bearing remover shaft, 15 mm
[5] Remover weight
07936-KC10200
07936-KC10100
077 41-0010201
Countershaft bearing:
Bearing remover head, 12 mm
Bearing remover shaft, 12 mm
Remover weight
07936-1660110
07936-1660120
077 41-0010201
U.S.A. TOOLS:
Driveshaft bearing:
Bearing remover, 15 mm
Remover
weight
Countershaft bearing:
Bearing remover,
12
mm
Remover handle
Remover
weight
07936-KC10500
07936-371020A
07936-16601
QA
07936-3710100
07936-371020A
Remove the final gear shaft oil seal
[6]
and bearing [7].
Apply engine oil to the drives haft bearing [1] and
countershaft bearing
[2]
cavity.
Set the bearings
Drive a new countershaft bearing
and
driveshaft
with their marked
bearing into the final reduction case squarely until they - -
sides facing
up.
are fully seated, using the special tools.
TOOLS:
Driveshaft bearing:
(3] Driver
[4] Attachment, 32 x 35 mm
[5] Pilot, 15 mm
Countershaft bearing:
Driver
Attachment, 32
x
35 mm
Pilot, 12 mm
077 49-0010000
077 46-0010100
077 46-0040300
077 49-0010000
07746-0010100
[5];,...
07746-0040200
~----
Apply engine oil
to
the final gear shaft bearing
[1]
cavity.
Set the bearing with
Drive a new final gear shaft bearing into the final
its marked side
reduction case squarely until
it
is
fully seated, using the
facing
up.
special tools.
TOOLS:
[2] Driver
[3] Attachment, 51.5 mm
[4]
Pilot, 25 mm
077 49-0010000
07946-3290000
077 46-0040600
REDUCTION
1 1
To Next Page
Loading...
Need help?
General
