Honda PCX150 2013 User Manual

CYLINDER HEADNALVES·
INSTALLATION
Install the cam chain guide
[1]
while aligning its pins
with the grooves
on
the cylinder
and
its end with the
groove
on
the right crankcase.
Clean the cylinder and cylinder head mating surface.
Do not reuse the old
Install the dowel pins [1] and a new gasket [2] onto the
gasket.
cylinder.
10-22
Route the cam chain
[1]
through the cylinder head [2]
and install the cylinder head onto the cylinder.
Apply engine
oil
to the seating surface and threads of
the cylinder head nuts [3], whole surface of the washers
[4] and cylinder stud bolt upper threads
[5].
Install the cylinder head nuts and washers, then tighten
them
in
a crisscross pattern to the specified torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft}
Install and tighten the cylinder head bolts [6].
Install the wire guides [1] and tighten the bolts [2].
[2]

Honda PCX150 2013 Specifications

General

Brand	Honda
Model	PCX150 2013
Category	Scooter
Language	English