GENERAL INFORMATION
SERVICE RULES
1.
Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that
do
not meet Honda's design
specifications may cause damage to the scooter.
2.
Use the special tools designed for this product
to
avoid damage and incorrect assembly.
3.
Use only metric tools when servicing the scooter. Metric bolts, nuts and screws are not interchangeable with English fasteners.
4.
Install new gaskets, 0-rings, cotter pins, and lock plates when reassembling.
5.
When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque diagonally
in
incremental steps unless a particular sequence
is
specified.
6.
Clean parts
in
cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7.
After reassembly, check
all
parts for proper installation and operation.
8.
Route all electrical wires
as
shown
in
the Cable and Harness Routing (page 1-19).
9.
Do not bend or twist control cables. Damaged control cables will not operate smoothly and may stick or bind.
ABBREVIATION
Throughout this manual, the following abbreviations are used to identify the respective parts or systems.
Abbrev. term
Full term
CBS
Combined brake system
CKP sensor
Crankshaft Position sensor
DLC
Data Link Connector
OTC
Diagnostic Trouble Code
ECM
Engine Control Module
ECT sensor
Engine Coolant Temperature sensor
EEPROM
Electrically Erasable Programmable Read Only Memory
EVAP
Evaporative Emission
IACV
Idle Air Control Valve
IAT sensor
Intake Air Temperature sensor
MAP sensor
Manifold Absolute Pressure sensor
MCS
Motorcycle Communication System
MIL
Malfunction Indicator Lamp
PGM-FI
Programmed Fuel Injection
SCS connector
Service Check Short connector
TP sensor
Throttle Position sensor
VS sensor
Vehicle Speed sensor
DESTINATION CODE
Throughout this manual, the following codes are used to identify individual types for each region.
DESTINATION CODE REGION
AC
50
state (meets California)
CM
Canada
1-2
To Next Page
Loading...
Need help?
General
