Xenon/Granit User Guide 97
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a base, scan the
Override Locked Scanner bar code below with a new scanner and place that scan-
ner in the base. The locked link is overridden, the broken or lost scanner’s link with
the base is removed, and the new scanner is linked to the base.
Out-of-Range Alarm
If your scanner is out range of the base, an alarm sounds from both your base and
scanner. The alarm stops when the scanner is moved closer to the base, when the
base connects to another scanner, or when the alarm duration expires. To activate
the alarm options for the scanner or the base and to set the alarm duration, scan
the appropriate bar code below and then set the time-out duration (from 0-3000
seconds) by scanning digits on the Programming Chart, beginning on page 353,
then Save.
Note: If you are out of range when you scan a bar code, you will receive an error tone even if
you do not have the alarm set. You receive the error tone since the data could not be
communicated to the base or the host.
Alarm Sound Type
You may change the alarm type for the scanner or a base by scanning the appropri-
ate bar code below and then scanning a digit (0-7) bar code from the Programming
Chart, beginning on page 353, then Save. Default = 0.
The sounds are as follows:
Override Locked Scanner
(Single Scanner)
Setting Sound
0 3 long beeps, medium pitch
1 3 long beeps, high pitch
2 4 short beeps, medium pitch
To Next Page
Loading...
Need help?
General