Xenon/Granit User Guide 129
Reread Delay
This sets the time period before the scanner can read the same bar code a second
time. Setting a reread delay protects against accidental rereads of the same bar
code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive bar code scanning is required. Reread Delay
only works when in a Presentation Mode (see page 122). Default = Medium.
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 353, then Save.
2D Reread Delay
Sometimes 2D bar codes can take longer to read than other bar codes. If you wish
to set a separate Reread Delay for 2D bar codes, scan one of the programming
codes that follows. 2D Reread Delay Off indicates that the time set for Reread
Delay is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
User-Specified Reread Delay
To Next Page
Loading...
Need help?
General