Xenon/Granit User Guide 55
Error Indicators
Beeper Pitch - Base Error
Note: This feature only applies to the CCB01-010BT base.
The CCB01-010BT base can be configured to beep at a particular pitch when an
error occurs, such as transmission problems to a host system. The beeper pitch
codes modify the pitch (frequency) of the error tone the base emits when there is
an error. Default = Low.
Number of Beeps - Base Error
Note: This feature only applies to the CCB01-010BT base.
The number of beeps and LED flashes emitted by the CCB01-010BT base for an
error condition can be programmed from 1 - 9. For example, if you program this
option to have five error beeps, there will be five error beeps and five LED flashes in
response to an error. To change the number of error beeps, scan the bar code below
and then scan a digit (1-9) from the Programming Chart, beginning on page 353,
then Save. Default = 1.
Number of Base Error Beeps/LED Flashes
To Next Page
Loading...
Need help?
General