52 Xenon/Granit User Guide
Base Power Communication Indicator
To display the power indicator on a base or an Access Point, scan the Base Power
Communication Indicator On bar code. To turn off the power indicator, scan the
Off bar code. Default = On.
Reset Scanner
Scanning this bar code reboots the scanner and causes it to relink with the base or
Access Point.
Scan While in Base Cradle
Note: This feature only applies to the CCB01-010BT base.
If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scan in Cradle On bar code below. If you want to only allow scanning
when the scanner is out of the base cradle, scan Scan in Cradle Off. If you want the
scanner to shut down when in the base cradle, scan Shut Down Scanner in Cradle.
Default = Scan in Cradle On (for CCB01-010BT).
Green LED - Scanner Battery
(base only, does not apply to Access Point)
Green LED Charge Condition
Off Battery not detected or charge
suspended
Slow flash, 1 second on, 1 second off Pre-charge and charging
On continuously Charge complete
Fast flash, 300 mSec on, 300 mSec off Charge Error
* Base Power Communication
Indicator On
Base Power Communication
Indicator Off
To Next Page
Loading...
Need help?
General