HP 9000 Series User Manual

FINAL TRIM SIZE : 7.0 in x 8.5 in
C
Note
If the search discovers ten devices, the lab el in the Device
Selection column for the ten
th entry is labeled P9 .Any
subsequententries are lab eled P* .
P* cannot be used as a device designator for bo ot administration commands
because it is am
biguous. To refer to a device labeled P* in a searc
h, specify it
by means of its en
try in the Device P
ath column.
To search to see which devices of just one t
ype actually contain b ootable
media, type the following at the BOOT_ADMIN> prompt:
search device type 4
Return
5
where device type is one of the following:
scsi is the built-in SCSI bus.
lan is all connections to the built-in LAN.
bpn is VME backplane networking.
eisa is the cards on the EISA bus.
You may also search for bo otable media from the main men
u of the Bo ot
Console User Interface by using a command in one of the fol lowing forms :
s 4
Return
5
s device type 4
Return
5
where device type is the typ e of device ( scsi or lan ) for whichyou wish to
search.
Redisplaying the Results of a Search
The list of bo otable devices is stored un
til you conduct another searchor you
rebo ot your system. To see the list of devices again, typ e the following at the
BOOT_ADMIN> prompt:
show 4
Return
5
It is much faster to redisplay the list with show than it is to conduct the search
again.
C-8 Using the Boot ROM DRAFT
2/5/97 11:31

HP 9000 Series Specifications

General

Brand	HP
Model	9000 Series
Category	Server
Language	English