FINAL TRIM SIZE : 7.0 in x 8.5 in
C
Setting the VME Backplane Netw
orking Parameters
The b o ot-administration
bpn_config
command allows you to conīgure the
VME backplane networking parameters: the CPU n
umb er on the bac
kplane,
the backplane anchor address, and the bac
kplane anchor AM co de. To display
this information, typ e the following at the
BOOT_ADMIN>
prompt:
bpn_config
The CPU number, backplane anchor address, and AM code will be prin
ted as
in the example belo
w:
Current configuration:
CPU No. 0
Anchor 0x00200000
AM code 0x3d
The values given above are also the default values for these models of the Series
700i.
Tochange the VME conīguration CPU numb er, Anchor, or AM co de, you will
need to change the p osition of the Service/Normal switch to \Service". (This
can be done without restarting the bo ot sequence or exiting the Bo ot Admin
mo de.) Then enter the numbers to b e changed after the
bpn_config
command,
in the following order:
1.
CPU number
2.
Anchor number
3.
AM code
To obtain help with this command, typ e
help bpn_config
.
DRAFT
2/5/97 11:31
Using the Boot ROM C-15
To Next Page
Loading...
Need help?
General