HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6.11.1 2-Port 40GBase LAN-CFP Line Processing Unit S(LPUS-101)
Overview
Figure 6-52 shows the appearance of the 2-Port 40GBase LAN-CFP Line Processing Unit
S(LPUS-101). HQoS is not supported on this board,The port can be configured to work in
LAN mode.
Figure 6-52 Appearance of the 2-Port 40GBase LAN-CFP Line Processing Unit S
Panel
Table 6-135 lists the indicators on the panel.
Figure 6-53 Appearance of the 2-Port 40GBase LAN-CFP Line Processing Unit S
Table 6-134 Indicators on the panel of the 2-Port 40GBase LAN-CFP Line Processing Unit S
It is an OFL button. Before removing a board, press the OFL button.
Hold the button for five seconds till the OFL indicator is on. Then, the
board can be pulled out.
If the indicator is steady on, it indicates that you can remove the
board.
If the indicator blinks once every 2s (0.5 Hz), it indicates that the
system is running normally. If the indicator blinks twice every 1s (2
Hz), it indicates that the system is in the alarm state.
If the indicator is steady on, it indicates that the link is normal. If the
indicator blinks, it indicates that data is being transmitted. If the
indicator is off, it indicates that the link is Down.
To Next Page
Loading...
Need help?
General
