Figure 7-167 Installing fan module brackets
Step 10 Install the fan modules. For details, see 7.16 Installing a Fan Module.
Step 11 Install the air duct. For details, see 7.14 Installing the Air Duct.
Step 12 Install full-height full-length riser cards if they are required. For details, see 7.20
Installing a Riser Card.
Step 13 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 14 Install the RH2288H V3. For details, see 3.4 Installing the Server.
Step 15 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 16 Power on the RH2288H V3. For details, see 4.1 Powering On the Server.
----End
7.67 Removing an M.2 SATA SSD Card
Remove an M.2 SATA SSD card if it has failed.
An M.2 SSD riser card can be congured with two M.2 SATA SSD cards. The
replacement method is the same for the two M.2 SATA SSD cards.
This section uses the M.2 SATA SSD card corresponding to SATA1 port as an
example.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server, and label its
panel to prevent misoperations.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 297
To Next Page
Loading...
Need help?
General